3. Setup of Software Development Environment
8
Seiko Epson Corporation
S1C31 Family Software Development
Setup Guide (Rev.4.0)
3.3 Connection of Hardware
This section describes how to connect the hardware of the software development. The debug probe recommended
for the S1C31 Family is I-jet or J-Link.
3.3.1
When Using the I-jet
(1) Connect I-jet to the PC with IAR EWARM installed using the USB micro cable included with I-jet. This
enables the PC to automatically install the device driver.
(2) Connect I-jet to the evaluation board(ex. S5U1C31xxxTx) using the cable and adapter included with I-jet.
(see Figures 3.3.1.1)
Figure 3.3.1.1 Hardware Connection using I-jet
*1
*1: Figure 3.3.1.1 shows an example when the evaluation board (S5U1C31xxxTx) works using 5V power supply
supplied from a debug probe (I-jet).
For more information on the connection of hardware with I-jet, refer to the “IAR Debugging probes User Guide”,
“S5U1C31xxxTx Manual” (listed in Table 2.2.1) as necessary.
USB cable with I-jet
Cable included with I-jet
Evaluation
Board
(S5U1C31xxxTx)
Adapter included with I-jet
I-jet
(IAR Systems)
