Measuring
Operation buttons
A
Display the measurement screen.
Press
C
on the time screen.
GPS positioning starts, and the measurement
screen is displayed once positioning is complete.
U
“Specifying a GPS (GPS Positioning)” on
B
Start measuring.
Press
C
.
C
Record the lap.
Press
D
while measuring.
The Lap Hold Screen* is displayed for 5 seconds,
and then the measurement screen is displayed.
U
* The screen display differs depending on the
settings.
U
“Screen pattern table” on page 101
D
Stop measuring.
Press
C
while measuring.
Press
C
to resume measuring.
E
Reset the measurement results.
Hold down
D
while measuring is stopped.
When you reset the display, it returns to the
status before measuring started allowing you to
start the next measurement.
Data measured up to that point is stored in the
device's memory, and you can check it by
pressing
D
on the time screen.
U
“Checking Measurement Data” on
SF-810 User Manual
Measure
41
Содержание Runsense SF-810
Страница 1: ...User Manual GPS Sports Monitor ...
Страница 90: ...How to Change the Settings SF 810 User Manual Settings 90 ...
Страница 126: ...Icon Name Setup from the external device SF 810 User Manual Appendix 126 ...
Страница 132: ...www epson eu runsense 412842700 2014 Seiko Epson Corporation All rights reserved GPS Sports Monitor ...