Epson R1800 - Stylus Photo Color Inkjet Printer, Руководство по обслуживанию

Страница: 151 / 234

EPSON Stylus Photo R1800/R2400 Revision B
Adjustment Adjustment 151
2. Connect the printer to the PC by a USB cable, and click [Next].
Figure 5-24. Checking the Printer Connection
3. The printer driver for Stylus Photo R1800 is automatically detected, and
the USB ID is automatically acquired.
4. To prevent inks from settling down at the bottom, remove all ink cartridges,
shake them at least four times, and reinstall them to the printer.
Figure 5-26. Ink Setup
5. To prevent inks from settling down at the bottom, cleaning cycles shown
below are performed.
„
Exchange CL (once) + CL3 (once)
Figure 5-27. Cleaning
C A U T I O N
„
The remaining amount of the ink is checked before the
USB ID is acquired. If there is an ink cartridge(s) with a
remaining amount of ink of 30% or less (ink low/ink out
states), a warning message is displayed.
„
As the USB ID is used to recognize printers when
entering color measurement values, do not change the
USB ID after performing the Colorimetric Calibration.
C H E C K
P O I N T
„
Only printers connected with USB are recognized.
„
When two or more printers are currently connected, the
screen changes to the "port selection" screen.
Figure 5-25. Selecting the Port
Warning
message