Epson Powerspan, Руководство пользователя, Страница: 76 / 219

SD command parameters (continued)
Parameter Mode Function
/ K Keyboard only Sets the program so a mouse
mode cannot be used, even if you have
installed one. In default mode, you
can use a mouse as long as a
mouse driver is loaded.
/M Monochrome Displays the program in black and
display mode white only. In default mode, color
monitors will display in color. Run
the program in this mode if you
have redirected the console
output to a serial port.
/N Non-target Allows you to run the EISA
modeling mode Configuration utility in non-target
modeling mode; see page 3-31 for
more information.
/P Permanent Reboots the system instead of
command exiting to your operating system.
interpretermode Use this mode if there is no
COMMAND.COM file installed on
your hard disk drive.
Using the CF Command
The CF command starts the EISA Configuration utility, but you
cannot run any other utilities. If you want to run the EISA
Configuration utility from your hard disk, first follow the
instructions under “Copying the Configuration Files to a Hard
Disk” on page 3-36.
Then follow these steps to use the CF command:
1. To run the utility from a diskette, insert the System
Configuration diskette in drive A and log onto drive A.
To run the utility from a hard disk, log onto the drive and
directory where you copied the configuration files.
3-34 Running the EISA Configuration Utility