Epson Powerspan, Руководство пользователя, Страница: 61 / 219

System board options (continued)
Option Settings Description
POST Memory Enabled * Set to Enabled to display the
Test Prompt Disabled skip memory test prompt when
you turn on or reset your
computer; select Disabled to
prevent display of the prompt
(You can still press the space-
bar to skip the test if you
disabled the prompt; see
Chapter 2)
POST Setup
Control Enabled -Prompt for Select Enabled -Prompt for
setup entry * setup entry to display the
Enabled -Suppress prompt to run the SETUP
setup prompt program when you turn on or
Setup Disabled reset the computer; select
Enabled -Suppress setup
prompt to prevent display of
the prompt; select Setup
Disabled to prevent entry into
the SETUP program until this
option is changed
Boot Device
Control Boot from Diskette or Select the device(s) from
Hard Drive * which you want to be able to
Boot from Hard Drive boot your system (4)
Only
Reserved [settings vary] Press Enter and F6 to display
System resources, such asinterrupts
Resources and memory addressranges,
reserved for use by the system
board
* Default setting
1 To boot your system from a SCSI hard disk drive, you must disable the
built-in IDE controller and set both hard disk drive types to Disabled.
2 You cannot set Serial Port 1 and 2 to the same address. If you attempt to
do so, you see an error message.
3 If you change the refresh rate, you must press the reset button or turn the
computer off and on again aftersaving your settings to reset the rate.
4 The Boot Device Control setting is ignored if the diskette drive iscontrolled
by a SCSI option card.
Running the EISA Configuration Utility 3-19