Epson PowerLite Pro G5900, Руководство пользователя

Страница: 69 / 140

Fine-Tuning the Projector
69
■ Auto Setup
Leave this setting
On
to automatically optimize computer
images. Turn it off if you want to save adjustments you have
made to the Tracking, Sync, and Position settings.
■ Resolution
Set to
Auto
to have the projector automatically identify the
resolution of the input signal. If necessary (because some of
the image is missing, for example), adjust to
Wide
or
Normal
. You can also select
Manual
and specify a resolution.
■ Tracking
Adjust this value to eliminate vertical stripes in computer
images.
■ Sync
Adjust this value if computer images appear blurry or flicker.
■ Position
If the image is slightly cut off on one or more sides, it may not
be centered exactly. Select this setting and use the
pointer
button to center it.
■ Progressive
For composite video, S-video, component video, and signals
from the HDMI port only. Turn this setting on to convert
interlaced signals into progressive signals (best for still
images). Select
Video
for viewing general video images. Select
Film/Auto
for movie images, CG, and animated images.
Leave the setting
Off
for moving images.
■ Noise Reduction
Smooths out rough images. Select the setting that makes the
selected input source look best. Epson recommends that you
select
Off
when viewing image sources with very low noise,
such as DVDs.
■ HDMI Video Range
When you connect to the HDMI input port, set the
projector’s video range to match the video range setting of
your device.
note
You can also use the remote
control’s
Auto
button to
automatically reset the
projector’s Tracking, Sync,
and Position settings. See
page 105 for details.
note
For component or RGB
video, the Progressive setting
can only be adjusted when
480i/576i/1080i signals are
being input.
note
The Noise Reduction,
Progressive, and Overscan
settings cannot be set for
digital RGB signals.