Epson PowerLite 5600p, Руководство пользователя

Страница: 85 / 114

Connecting to Additional Equipment
79
To install EMP Link V, insert the Projector Software CD-ROM in
your CD-ROM drive and follow the instructions on the screen. The
installation program also installs the
EMP Link V User’s Guide on your
hard disk. You can access this manual in the EMP Link V folder for
complete instructions on using the program.
Connecting to an External Audio System
The projector’s internal speakers are loud enough for most rooms.
However, if your installation requires maximum volume and sound
quality, you can connect the projector to external speakers or a public
address (PA) system. This disables the projector’s internal speakers.
If you’ve connected multiple audio and video sources to the projector,
the projector will automatically switch the audio along with the video
source whenever you choose a different video source. (See “Switching
Between Picture Sources” on page 29 or page 34.)
To connect the projector to an external sound system, you will need
an RCA-to-3.5 mm stereo audio cable, which may be included with
your sound system, or may be purchased from an electronics store.
Before you start, make sure the projector and speakers or PA system
are turned off.
1. Connect the cable’s 3.5-mm stereo miniplug to the projector’s
Audio Out
jack.
2. Connect the RCA plugs on the opposite end of the cable to the
left and right jacks of your speaker or PA system.
audio cable
5600 and 7600.book Page 79 Thursday, December 14, 2000 2:46 PM