Epson PowerLite 5600p, Руководство пользователя

Страница: 38 / 114

32
Using the Remote Control
Installing the Batteries
Follow these steps to install the remote control’s batteries:
1. Press the tab to release the
battery compartment cover.
2. Remove the cover and insert
the two AA batteries included
with the projector as shown.
3. Replace the battery
compartment cover.
Before you can use the remote
control, you need to turn it on as
described below.
Turning On the Remote Control
Make sure the batteries are installed. Then push up the on/off switch
on the side of the remote control to turn it on.
If you want to make sure the batteries are good, press the round
light button. The other buttons on the remote should light up
temporarily. If they don’t, you need to change the batteries as
described above.
Turn off the remote control before transporting it or storing it with
the projector in a carrying case; this prevents the batteries from
discharging if something presses against one of the remote control’s
buttons.
caution
When replacing batteries,
take the following
precautions:
■
Don’t mix old and new
batteries.
■
Replace batteries as soon as
they run out. If the
batteries leak, wipe away
battery fluid with a soft
cloth. If fluid gets on your
hands, wash them
immediately.
■
Remove batteries if you
won’t be using the remote
control for a long time.
tab
Power
Freeze
A/V Mute
E-Zoom
R/C ON
OFF
3
1
5
2
4
Enter
Esc
on/off
switch
light
button
5600 and 7600.book Page 32 Thursday, December 14, 2000 2:46 PM