63
Setting Up Monitoring Using SNMP
Network administrators can install SNMP (Simple Network Management Protocol) software on network
computers so they can monitor projectors. If your network uses this software, you can set up the
projector for SNMP monitoring.
1.
Press the
Menu
button.
2.
Select the
Network
menu and press
Enter
.
3.
Select
Network Configuration
and press
Enter
.
4.
Select the
Notifications
menu and press
Enter
.
5.
Turn on the
SNMP
setting.
6.
Enter up to two IP addresses to receive SNMP notifications, using 0 to 255 for each address field.
Note:
To enter the IP address using the numeric keys on the remote control, press and hold the
Num
button. Do not use these addresses: 127.x.x.x or 224.0.0.0 through 255.255.255.255 (where x
is a number from 0 to 255).
7.
If you want this projector to receive broadcasted messages over the network, select the
Others
menu and turn on the
Message Broadcasting
setting. Administrators can broadcast messages over
the network using Epson Projector Management (Windows only).
8.
When you finish selecting settings, select
Complete
and follow the on-screen instructions to save
your settings and exit the menus.
Содержание PowerLite 1266
