Epson ME100, Руководство по обслуживанию

Страница: 116 / 135

EPSON Stylus CX1500/ME100 Revision A
MAINTENANCE Overview 116
6.1 Overview
This section provides information to maintain the printer in its optimum condition.
6.1.1 Cleaning
This printer has no mechanical components which require regular cleaning except the
Print Head. Therefore, when returning the printer to the user, check the following parts
and perform appropriate cleaning if stain is noticeable.
V
Exterior parts
Use a clean soft cloth moistened with water, and wipe off any dirt. If the exterior
parts are stained by the ink, use a cloth moistened with neutral detergent to wipe it
off.
V
Inside the printer
Use a vacuum cleaner to remove any paper dust.
V
LD Roller
When paper loading function does not operate because friction of the LD Roller is
lowered by any paper dust, set the adhesive side up of the cleaning sheet (included
in the media) to remove any paper dust. Repeat loading the cleaning sheet several
times.
V
Document glass
Remove dust or any paper with a clean dry cloth. In case dirt is serious or alien
substance is stick, wipe it off with a cloth moistened with neutral detergent. In case
Stain is remained, wipe again with a dry clean cloth.
6.1.2 Service Maintenance
If any abnormal print (dot missing, white line, etc.) has occurred or the printer indicates
the “Maintenance request error” (This error is displayed as “Maintenance call error” in
the STM3), take the following actions to clear the error.
V
Print Head cleaning
When dot missing or banding phenomenon has occurred, you need to perform the
Print Head cleaning operation*
1
by using the Print Head cleaning function. This
function can be performed by the control panel operation, the printer driver utility
and the Adjustment program.
In case that the cleaning sequence is performed by the control panel operation,
confirm that the printer is in stand-by state (the Power LED is lighting), and hold
down the Ink Maintenance button on the control panel between 3 to 6 seconds.
Then, the printer starts the cleaning sequence (the Power LED blinks during this
sequence).
In case that you select and perform the manual cleaning by the printer driver
utility, the most appropriate cleaning mode is selected. The following is the
process to perform the Print Head cleaning from the printer driver utility.
As for the operation of the Adjustment program, refer to Chapter 5 Adjustment.
NOTE: *1: The Stylus CX1500/ME100 has 3 modes for manual cleaning,
and even during printing, the appropriate cleaning mode is
automatically selected and perfomrmed according to various
conditions. Therefore the ink consumption amount for manual
cleaning varies depending on each mode (Refer to Chapter 2).
C A U T I O N
T
Never use chemical solvents, such as thinner, benzine, and
acetone to clean the exterior parts of the printer like the
Housing. These chemicals may deform or deteriorate the
components of the printer.
T
Be careful not to damage any components when you clean inside
the printer.
T
Do not scratch the coated surface of the PF Roller Unit. Use soft
brush to wipe off any dusts. Use a soft cloth moistened with
alcohol to remove the ink stain.
T
Do not use cleaning sheet included in the media for normal
usage. It may damage the coated surface of PF Roller Unit.
If the adhesive surface of the cleaning sheet is set to the LD
Roller shaft side and used to clean the LD Roller surface, it is no
problem.