Start Here
3
Load paper
1
Make sure the product is not charging ink. Then flip the
feeder guard forward, raise the paper support, and tilt it
backwards slightly.
2
Slide the edge guide to the left.
3
Load paper, glossy or printable side up and short edge
first, against the right side of the rear paper feed slot.
4
Slide the edge guide against the paper, but not too tightly,
and flip the feeder guard back.
5
Pull out the output tray and raise the paper stopper.
Read these instructions before using your product.
1
Unpack
Note:
Do not open the ink bottles until you are ready to fill the ink
tanks. The ink bottles are vacuum packed to maintain reliability.
1
Remove all protective materials from the product.
2
Lift up the scanner unit and remove all protective materials
from inside the product.
Caution:
Do not touch the flat white cable or the ink tubes and
their translucent cover.
3
Lower the scanner unit.
2
Fill ink tanks
Note:
This product requires careful handling of ink. Wear disposable
gloves and place a sheet of paper under the ink tank unit when you
fill or refill the ink tanks, as ink may splatter. If ink spills, wipe it off
immediately with a damp towel to avoid permanent stains. If ink gets on
your clothes or belongings, it may not come off.
Caution:
Keep the ink bottles out of the reach of children and do not
drink the ink.
1
Open the ink tank unit cover, then remove the cap for the
cyan ink tank and attach it to its holder.
2
Unpack the cyan ink bottle.
3
Snap the bottle tip off, then remove the bottle cap.
Carefully remove the protective seal (avoid touching the ink
underneath the seal), then close the bottle cap
tightly.
Caution:
Be sure to close the bottle cap tightly, or ink may leak.
4
Fill the tank using all of the ink in the bottle.
Note:
Refer to the color coded sticker on the ink tank unit cover
to identify the color of each tank.
Caution:
Be sure to fill each tank with the correct ink color.
5
Carefully seal the bottle using the reverse side of the bottle
tip for proper disposal.
6
Replace the ink tank cap securely.
7
Repeat the previous steps for the remaining bottles.
8
Close the ink tank unit cover.
9
Connect the power cord to the back of the product and to
an electrical outlet.
Caution:
Do not connect to your computer yet.
10
Raise the control panel and turn on the product. Wait for
the power light to stop flashing.
Note:
If all the product lights are flashing, turn off the product
and check that no protective material has been left inside
the product.
Caution:
Do not lower the control panel without first squeezing
the release bar underneath or you may damage the product.
11
Press the
stop button for 3 seconds until the power
light starts flashing, to begin charging the ink. Ink charging
takes approximately 20 minutes. Ink charging is complete
when the power light stops flashing.
20 minutes
3 seconds
Note:
The ink bottles included with the printer are designed
for printer setup and not for resale. After some ink is used for
charging, the rest is available for printing.
Caution:
Do not turn off the product or load paper while the
product is charging or you’ll waste ink.
L375
4129504 Rev.0
1-F
C
4129504 Rev.0
1-F
M
4129504 Rev.0
1-F
Y
4129504 Rev.0
1-F
K
