3.
Hook the tension lever onto both ends of the stand as shown below.
While pulling up the tension lever, fit the wire ends of the tension
lever into the holes in the stand. The roll paper holder is assembled.
Installing the roll paper holder
1.
Make sure the printer is turned off.
2.
Position the roll paper holder underneath the printer as shown below.
Fit the two positioning pegs on the bottom of the printer into the two
holes in the base plate.
c
Caution:
The roll paper holder is not fastened to the printer; only the printer’s
weight and the two positioning pegs hold it in place. If you pick up the
printer, be careful not to drop the roll paper holder.
To remove the roll paper holder, carefully lift up the printer and pull out
the roll paper holder from beneath the printer.
tension lever
g3-30-3
4-6
A
R
Sun-G+
Rev.C
A5 size
Appendix A
97/11/14
pass 1
Enhancing Your Printer With Options
A-13
