You must correct the information stored in the CMOS RAM.
To do this, run the Setup program on your Reference diskette.
See Chapter 2 for instructions.
RAM Check
The computer next begins to check the RAM installed on the
main system board and any option cards. During the check, you
see this message:
nnnnnn
KB 0K
where nnnnnn indicates the amount of memory in which no
malfunction is found. This value increases continuously by
64KB up to the amount of RAM installed on the main system
board, which is 640KB. If the computer detects an error in the
first 64KB area, it displays an error message and halts with no
further information.
If there are faulty RAM chips in your system, you see one of
these messages:
202-Memory
203-Memory
If an I/O or parity error occurs, you see one of these messages:
1
2
The program also displays the number of the segment causing
the problem.
Power-on Diagnostics B-3
Содержание Equity IIe
