Epson Ensemble HD, Руководство по установке

Страница: 44 / 71

44
Install the Tracks and Connector Pieces
1
Plan your layout of the wire management system, referring to the illustration below. If you want to connect
two 8-foot tracks together (end-to-end), use a seam cover where the tracks meet. Use the small connector
pieces to turn corners and transition from the wall to the ceiling. Use a hacksaw to cut the tracks to desired
lengths.
Tip
When using a hacksaw, cut the plastic slowly to maintain smooth edges.
Note
The example shown below is for a typical installation, but yours may vary. For example, if you plan to have your AV
equipment on the right side of the screen, you should attach the tracks to the wall on the right side instead of the left.
2 Attach the tracks and connector pieces to your wall and ceiling using the adhesive backing. To orient the
parts correctly, take note of the following:
• When connecting two tracks together, you need to make sure the channels inside the tracks line up
where the pieces meet. Colors are marked on the ends of the tracks to assist with this. You may have to
rotate a length of track end-for-end to make the channels (and colors) line up.
• When using a corner connector, make sure the channels inside the corner connector and in the two
tracks all line up.
3
Use the included drywall screws to secure the tracks and connector pieces to the wall and ceiling. Insert the
screws at the pre-drilled locations.
Note
Depending on your installation, it may not be necessary to insert screws at all the pre-drilled locations (for example,
you may be able to insert a screw in every other hole).
Seam cover
Wall-to-ceiling transition
Corner connector