Epson Ensemble HD, Руководство по установке

Страница: 26 / 71

26
Connect the Cables to the Screen
Before lifting the screen onto the mounting brackets, you’ll need to connect the cables to the screen. This is
best done with the screen resting right-side-up on a carpeted floor or other soft surface.
All the cables are grouped together by length. To avoid mixing up the cables, unpack them in the order they’re
called for in the instructions.
When you’re done connecting the cables, you should have a total of four cables from the subwoofer and
AV controller entering the screen from the left or right side, depending on where the subwoofer will be located.
(It is preferred that the cables enter the screen from the left, so that excess cabling, if any, can be stored inside
the right side of the screen.) In addition, the four cables that go from the screen to the projector should leave
the screen from the middle. Let the loose ends of the cables hang out of the screen housing when you’re done
connecting them. Do not connect them to the projector, subwoofer, or AV controller yet.
1
Locate
AC CABLE 2
, packed in the AC power cable box inside box #5 with the subwoofer.
2 Connect
AC CABLE 2
to the control box inside the screen, as shown below.
Note
It’s a good idea to check that the control box comes on when you apply power. Temporarily plug the power cord
into a wall outlet and make sure the red LED on the control box comes on. If it doesn’t, make sure the wall outlet is not
controlled by a power switch and is actively supplying power. Unplug the power cord from the wall outlet when
you’re done with this test.
3 Locate the
10M KIT
packed in box #3. The 33-foot (10-meter) cables included in this kit connect the AV
equipment (subwoofer and AV controller) to the screen.
Red LED
To subwoofer
(do not connect yet)