Epson Ensemble HD, Руководство по установке

Страница: 23 / 71

23
5
Use a level to make sure the alignment bar isn’t tilted to one side. Align one of the end brackets with the
stud you marked on the wall and attach it with two wood screws.
Caution
The bar must be level, or the screen will not deploy properly. A slight tilt may cause screen failure over time.
6 Attach the bracket at the opposite end of the alignment bar. If necessary, loosen the screw on the face of the
bracket to slide it on the bar and align it with the stud. Align the holes in the bracket with the center of the
stud.
7
Tighten the screw on the face of each bracket to secure it to the alignment bar.
8 Determine where the middle of the screen will be. Then position the middle bracket so it’s aligned with the
middle of the screen. The set screw in the middle of the screen must engage with the bracket.
9 If the middle bracket aligns with the center of a stud (see drawing below), attach it to the wall with two
wood screws; otherwise use two Toggler wall anchors, included. If necessary, you can move the bracket
slightly left or right to align the holes with a stud, as long as at least part of the bracket remains aligned
with the middle of the screen.
Important
At least part of the bracket must align with the middle of the screen.
10 Tighten the two screws on the face of the bracket to secure it to the alignment bar.
Attach bracket to
stud in wall
Loosen screw to slide bracket
on alignment bar
®
Align two holes with
stud, if possible, and
fasten with wood screws
If attachment to stud is not
possible, then attach with
two Toggler anchors here