Epson EMP-TS10, Руководство пользователя

Страница: 9 / 72

7
Basic Operations
Procedure
1
Turn on the power for all equipment
connected to the projector.
For a video source, press the [Play] button at the
video source to start playback if necessary.
Check that the
indicator on the projector has
stopped flashing and lights orange.
2
When using the remote control, set the
R/C switch on the remote control to ON.
3
Press the [Power] button on either the
remote control or the projector's
control panel to turn on the power for
the projector.
The indicator flashes green, and after a short
period projection starts.
Check that the
indicator has stopped flashing
and lights green. (This takes approximately 30
seconds.)
4
If more than one signal source has been connected, use the remote control or
control panel buttons to select the port which the signal source that you
would like to use is connected to, while referring to the following table.
*The display disappears after 3 seconds.
Turning On the Power and Projecting Images
The buttons on the remote control and the projector's control panel cannot be operated
while the
indicator is flashing green. Wait until it lights steadily.
The message "No-Signal." may appear depending on the projector's menu settings. (p.24)
Port
Button to press
Display at bottom-left of
screen
* Control panel Remote control
Computer1
[Computer/YCbCr ]
[Comp1]
Computer1(Digital-RGB)
Computer1(Analog-RGB)
Computer1(RGB-Video)
Computer2/Component
Video
[Comp2/YCbCr]
Computer2(Analog-RGB)
Computer2(RGB-Video)
Computer2(YCbCr)
Computer2(YPbPr
)
S-Video
[Video]
[S-Video] S Video
Video [Video] Video
Lights green
Remote control
Connecting the Power Cord
Turning On the Power and Projecting Images