Epson EMP-S4, Руководство по обслуживанию

Страница: 98 / 102

5-2
EMP-S4
SEIKO EPSON Revision:B
5.1 AS (After Service) Menu
The AS (After Service) menu provides information and settings that are not displayed on the
standard menu.
5.1.1 How To Display the AS (After Service) Menu
Press
the Menu
button on either the remote control or the projector's control panel for at least 7
seconds. Within 4 seconds after pressing
the Menu
key, hit these buttons in order shown below
to display AS menu.
Esc
→
Esc
→
Tele
→
Wide
„
When the video source is PC type, Component type, the following screen appears.
C A U T I O N The contents of this chapter are for use only by Epson Authorized Servicers, and
are not to be disclosed to others without the express written consent of Epson.
C omputer C omputer
Input Signal Input Signal : ---- (---- ) : ---- (---- )
Frequency Frequency : H 0 . 000 kHz / V 0 . 000 Hz : H 0 . 000 kHz / V 0 . 000 Hz
Sync P olarity Sync P olarity : H -------- / V -------- : H -------- / V --------
Sync Mode Sync Mode : ---- : ----
Detected C omp Mode Detected C omp Mode : XXXXXXXXXXXXXXX : XXXXXXXXXXXXXXX
Total Operation Time Total Operation Time : 0 H : 0 H
Lamp Op. Time ( C ) Lamp Op. Time ( C ) : 0 H : 0 H
(H/M/L) (H/M/L) : 0 H / 0 H / 0 H : 0 H / 0 H / 0 H
Lamp Replacement Lamp Replacement : 0 Times : 0 Times
Lamp ON/LampOFF Lamp ON/LampOFF : 0 Times / 0 Times : 0 Times / 0 Times
C ool Down C ompleted C ool Down C ompleted : 0 Times : 0 Times
Fatal Error Fatal Error : T 0 L 0 I 0 : T 0 L 0 I 0
Destination Destination : XXXXXXXX : XXXXXXXX
Engine Type Engine Type : XXXXXXX : XXXXXXX
P P XXXXXXXXXXXXXXX XXXXXXXXXXXXXXX
O O ------------------ ------------------
J XXXXXXXXXXXXXXX J XXXXXXXXXXXXXXX
The last four digits show the PW
firmware version.
The last four digits show the Y43
firmware version.
•
Fatal Error: Abnormal termination
counter
Displays the number of times of each
of the following abnormal termina-
tions.
T: Temperature problem
L: Lamp problem
I: Internal problem
(Same as for S-Video and Video)