Epson EMP 30 - PowerLite 50c XGA LCD Projector, Руководство пользователя

Страница: 25 / 80

20
Setting Up the Projector
Before you start, make sure the projector and your component video
source are turned off.
1. Connect the red and white plugs on the A/V cable to the
projector’s
Audio L
(white) and
R
(red) jacks.
2. Connect the red and white plugs at the other end of the A/V cable
to the corresponding audio output jacks on your video source.
3. Connect the 15-pin connector on the component video cable to
the projector’s computer port.
4. Connect the green, blue, and red jacks on the other end of the
cable to these ports on your component video source:
■
Y
(green)
■
Pb
or
Cb
(blue)
■
Pr
or
Cr
(red) port.
5. Select the correct settings for your component video source by
selecting the following in the projector’s Video menu (as
described on page 38):
■
If you connected the projector to a DVD player, select
YCbCr
as the Input Signal setting.
■
If you connected an HDTV source or if your DVD player
supports YPbPr, select
YPbPr
as the Input Signal setting and
16:9
as the Aspect Ratio setting.
RCA
audio/video cable
component video cable
(not included)