Using Multiple Projectors
93
a
If you are using a high-functioning Epson projector remote
control and you select
Advanced
as the
Remote Control Type
setting, select the identification number, select
Set
, and then
press [Enter].
s
Extended
>
Operation
>
Advanced
>
Remote Control Type
e
Press [Menu] or [Esc] to exit the menus.
f
Repeat these steps for all the other projectors you want to operate from
one remote control.
Selecting the Projector You want to Operate
After setting the projector's ID, select the ID for the projector you want to
operate using the remote control.
a
Aim the remote control at the target projector and press the [ID]
button.
The current Projector ID is displayed on the projected screen. It
disappears after about 3 seconds.
b
While holding the [ID] button, press the number button that matches
the ID of the projector you want to operate.
The projector you want to operate is selected.
c
Press the [ID] button to check if the ID-setting process worked.
You see a message displayed by the projector.
• If the remote control is listed as
On
, you can operate the projector
from the remote control.
• If the remote control is listed as
Off
, you cannot operate the projector
from the remote control. Repeat the steps above to enable the remote
control.