Epson EB-L25000U, Руководство пользователя

Страница: 194 / 231

Management Using SNMP
By setting SNMP to On in the Configuration menu, notification messages
are sent to the specified computer when a problem or warning occurs. This
allows you to check for problems with projectors even at locations away
from the projectors.
s
Network - Notifications - SNMP p.134
a
•
SNMP should be managed by a network administrator or someone
who is familiar with the network.
•
To use the SNMP function to monitor the projector, you need to
install the SNMP manager program on your computer.
•
The SNMP Agent for this projector complies with version 1
(SNMPv1).
•
The managing function using SNMP cannot be used over wireless
LAN in Quick connection mode.
•
Up to two destination IP addresses can be saved.
ESC/VP21 Commands
You can control the projector from an external device using ESC/VP21.
Command list
When the power ON command is transmitted to the projector, the power
turns on and it enters warm-up mode. When the projector's power has
turned on, a colon ":" (3Ah) is returned.
When a command is input, the projector executes the command and
returns a ":", and then accepts the next command.
If the command being processed terminates abnormally, an error message is
output and a ":" is returned.
The main contents are listed below.
Item Command
Power ON/OFF
On PWR ON
Off PWR OFF
Signal selection
Computer Auto SOURCE 1F
RGB SOURCE 11
Component SOURCE 14
BNC Auto SOURCE BF
RGB SOURCE B1
Component SOURCE B4
HDMI SOURCE 30
LAN SOURCE 53
SDI SOURCE 60
DVI-D SOURCE A0
HDBaseT SOURCE 80
Shutter function
On/Off
On MUTE ON
Off MUTE OFF
Add a Carriage Return (CR) code (0Dh) to the end of each command and
transmit.
For more details, contact your local dealer or the nearest address provided
in the Epson Projector Contact List.
s
Epson Projector Contact List
Cable layouts
Serial connection
•
Connector shape: D-Sub 9-pin (male)
Monitoring and Controlling
194