Epson EB-G5450WU, Руководство пользователя

Страница: 73 / 171

Others Menu
Sub Menu Function
SNMP
Set this parameter to On when using SNMP
g
to monitor the projector.
To use SNMP to monitor the projector, you need to install the SNMP manager program on your computer. SNMP should be managed by a network
administrator.
Trap IP Address 1/Trap IP
Address 2
When SNMP is set to On , you can set up to two IP addresses as SNMP trap notification destinations.
You can input a number from 0 to 255 in each field of the address.
However, the following IP addresses cannot be used.
127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a number from 0 to 255)
Priority Gateway
For the priority gateway, select either Wired or Wireless .
AMX Device Discovery
When the projector is connected to a network, set this to On to allow the projector to be detected by AMX Device Discovery
g
. Set this to Off if you are
not connected to an environment controlled with a controller from AMX or AMX Device Discovery.
RoomView
Set this parameter to On only when using Crestron RoomView
®
to monitor and control the projector over a network. Normally, leave this parameter set
to Off .
s
"About Crestron RoomView®" p.112
Changes in projector settings take effect upon restarting.
The following functions cannot be used when it is set to
On .
•
Web Control
•
Message Broadcasting (EasyMP Monitor plugin)
Network Menu
73