Epson EB-1930, Руководство пользователя

Страница: 98 / 146

Others menu
Submenu Function
SNMP
Set to On to monitor the projector using SNMP.
To monitor the projector, you need to install the SNMP manager
program on your computer. SNMP should be managed by a
network administrator.
The default value is
Off .
Trap IP Address
1/Trap IP Ad‐
dress 2
You can register up to two IP addresses for the SNMP trap
notification destination. You can enter a number from 0 to 255 in
each field of the address. However, the following IP addresses
cannot be used. 127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x
is a number from 0 to 255)
AMX Device Dis‐
covery When you want to allow the projector to be detected by AMX
Device Discovery
g
, set this to On . Set this to Off if you are not
connected to an environment controlled by a controller from
AMX or AMX Device Discovery.
Submenu Function
Crestron Room‐
View
Set this to On only when monitoring or controlling the projector
over the network using Crestron RoomView
®
. Otherwise, set
this to Off .
s
"About Crestron RoomView
®
" p.80
When this is set to On , the following functions are not available.
•
Web control
•
Message Broadcasting (EasyMP Monitor Plug-in)
Bonjour Set this to On when connecting to the network using Bonjour.
See Apple's Web site for more information on the Bonjour
service.
http://www.apple.com/
Message Broad‐
casting
You can switch the EPSON Message Broadcasting function to
enable or disable.
You can download Message Broadcasting and its Operation
Guide from the following Web site.
http://www.epson.com
List of Functions
98