Epson C11CF85403, Руководство пользователя

Страница: 33 / 242

G
Touch Enter Password and enter the password.
Note:
❏
Differentiate between uppercase and
lowercase when entering the password.
❏
If the SSID was entered directly, set Password
to Available before entering the password.
H
When input is finished, touch OK .
I
Check the settings and then touch Start Setup .
J
Touch
OK
to finish the procedure.
If the connection fails, select
Print Check Report
to print a network connection check report. You
can check the measure to take in the report.
K
Close the Network Connection Settings screen.
Directly Connection
Wirelessly (Wi-Fi Direct)
A direct connection with the printer can be established
temporarily when, for example, the printer is not
connected to a network or you do not have permission
to log on to the network.
Wi-Fi Direct is disabled by default. The following
describes the procedure from enabling Wi-Fi Direct to
connecting.
Note:
The printer can connect with up to four smart devices or
computers at the same time. If you want to connect
another device when there are already four devices
connected, disconnect the connection with the printer
from an already connected device.
A
Touch on the Home screen.
Note:
The shape and color of the icon differ depending on
the connection status.
U
“Home screen operations” on page 15
B
Touch Wi-Fi Direct .
When Wi-Fi Direct is already enabled, the
network (SSID), password, number of connected
devices, etc. are displayed. Proceed to step 5.
Note:
When any of the displayed network (SSID), device
name, etc. is partially not visible because it is cut off
at the right edge of the screen, touch the
corresponding item to display the entire setting
value.
C
Touch Start Setup .
D
Touch
Start Setup
.
Wi-Fi Direct is enabled and the network (SSID),
password are displayed.
E
Open the Wi-Fi setting screen on the device you
want to connect with the printer, select the SSID
displayed on the screen of the printer, and enter
the password just as it is displayed on the screen.
F
When a connection is established, touch Close to
finish the procedure.
G
Touch Close on the screen of the printer to close
the network connection settings screen.
When the printer driver is installed on the connected
device, you can print using the printer driver.
Note:
When you turn off the power of the printer, the
connections with connected devices are all disconnected.
To reconnect after turning the printer back on, perform
the procedure again from step 1.
SC-T5400 Series/SC-T5400M Series/SC-T3400 Series/SC-T3400N Series User's Guide
Changing the Network Connection Methods
33