1.
Turn off the projector and unplug the power cord.
2.
Gently remove the dust using a small vacuum designed for computers or a very soft brush (such as
a paintbrush).
Note:
You can remove the air filter so you can clean both sides of it. Do not rinse the air filter in
water, or use any detergent or solvent to clean it.
Caution:
Do not use canned air. The gases may leave a residue or push dust and debris into the
projector's optics or other sensitive areas.
3.
If dust is difficult to remove or the air filter is damaged, replace the air filter.
Parent topic:
Air Filter and Vent Maintenance
Replacing the Air Filter
You need to replace the air filter in the following situations:
• After cleaning the air filter, you see a message telling you to clean or replace it
• The air filter is torn or damaged
You can replace the air filter while the projector is mounted to the ceiling, if necessary. The illustrations
here show the projector placed on a table.
1.
Turn off the projector and unplug the power cord.
169
Содержание BrightLink 421i
