Epson Aculaser M1200 series, Руководство пользователя

Страница: 104 / 139

The Ready light is on but nothing prints
Cause What to do
Your computer may not be properly connected to the
printer. Perform the procedure described in the Setup Guide.
The interface cable may not be plugged in securely. Check both ends of the cable between the printer and
the computer. Be sure to secure the connector using the
wire retaining clips.
You may not be using the correct interface cable. If you are using the parallel interface, make sure you use
a double-shielded, twisted-pair interface cable no longer
than six feet in length.
If you are using the USB interface, use a Revision 2.0 cable.
The application that you are using to print may be the
problem. Quit the application, and restart your computer. Then try
printing again.
Your computer may not have enough memory to print
the data. Reduce the contents of the print job, or add memory to
your computer for a more permanent solution.
Printout Problems
Some or all of the printout is garbled or printed as asterisks
Cause What to do
The interface cable may not be plugged in securely. Make sure that both ends of the interface cable are
plugged in securely.
You may not be using the correct interface cable. If you are using the parallel interface, make sure that the
cable is a double-shielded, twisted-pair interface cable
no more than six feet in length.
If you are using the USB interface, use a Revision 2.0 cable.
Position of the printout is not correct
Cause What to do
The page length and margins are set incorrectly in your
application software. Make sure that you are using the correct page length
and margin settings in your application software.
EPSON AcuLaser M1200 Series User’s Guide
Troubleshooting 104