Epson Aculaser CX21N Series, Руководство пользователя

Страница: 116 / 401

Using the PostScript Printer Driver 116
For Macintosh
Any Macintosh computer to which the printer is connected must be running or Mac OS X
ver. 10.2.8 or later. See the following table for details.
Note:
To use the PostScript 3 printer driver with a USB interface, your computer must be Macintosh OSX
10.3.9 or later.
Mac OS X
Note:
To use binary data, Epson recommends that you use AppleTalk for the printer’s network
connection. If you use a protocol other than AppleTalk for the network connection, you need to set
Binary
to
On
in the
PS3 Menu
on the control panel. If you use the printer with a local connection, you
cannot use binary data.
Using the PostScript Printer Driver with Windows
To print in the PostScript mode, you will have to install the printer driver. See the
appropriate sections below for installation instructions according to the interface that you
are using to print.
Installing the PostScript printer driver for the USB interface
New :including the information about Windows 95
Follow the steps below to install the PostScript printer driver for the USB interface.
c
Caution:
Never use EPSON Status Monitor when the printer is connected via a USB port. It may
damage the system.
Memory 8 MB 16 MB
Minimum Recommended
Computer Power Mac G3, G4, G5, iMac, eMac, PowerBook G3, G4, or iBook
Hard Disk —
Memory 128 MB