Removing an Option Card
You may need to remove an option card to access components
on the main system board or if you no longer need it. Refer to
the illustrations for your computer and slot type under
“Installing an Option Card” as you follow these steps:
1.
If you are removing a card from one of the half-length slots
in the slimline computer, first remove the slot cover
bracket. Then pull the card straight out of the slot.
2.
If you are removing a card from the tower computer or from
one of the full-length slots in the slimline computer, remove
the retaining screw securing the option card to the
computer. Then pull the card straight out of the slot.
3.
If you are not installing another option card, replace the
option slot cover, the slot cover bracket (if necessary), and
retaining screw(s).
4.
Replace the computer’s cover; see “Replacing the Cover.”
Then see “Post-installation Procedures” for instructions on
configuring your computer without your option card.
Adding Video Memory
Your computer comes with 1MB of video memory. You can
increase your video memory to 2MB by installing two 512KB,
40-pin, SOJ flat pack video DRAM chips. Additional video
memory is useful for running graphics-intensive applications
or for supporting high resolutions with many colors.
Note that your video memory sockets may not look exactly like
the ones in the illustration. If you’re not sure how to install
video memory, contact your Authorized EPSON Servicer or the
EPSON Connection and ask for assistance.
4-22
Installing and Removing Options
Содержание ActionPC 8000
Страница 5: ......
