If your system is configured to automatically start Microsoft
Windows or a word processing program, or has a different
operating system, you will see the first menu or screen of that
program displayed at this point. If your system is not
configured to start like this, you will see the MS-DOS operating
prompt, such as
C:\>
or A:\>, each time you turn on the
computer.
Now follow the instructions below to configure your system
using the SETUP program.
Turning Off the Computer
Whenever you turn off your system, follow these steps:
1.
Save your data and exit any application program you are
using.
2.
Check the hard disk drive light and the diskette drive light(s)
to make sure they are not on. Do not turn off the computer
if a drive light is on, because you can damage the drive or
lose data.
3.
Remove any diskette(s) from the diskette drive(s).
4.
Press the power button to turn off the computer and then
turn off the monitor, printer, and any other peripheral
devices.
Running the SETUP Program
Be sure to run SETUP the first time you use your computer, so
you can verify or update the configuration information. You
also may need to run SETUP again later if you change your
configuration.
Setting Up Your System
1-9
Содержание ActionPC 2000
Страница 1: ...EPSON ACTION PC 2000 USER S GUIDE ...
Страница 2: ...EPSON User s Guide Printed on recycled paper with 10 post consumer content ...
Страница 109: ......
Страница 113: ......