Epson ActionDesk 4000, Руководство пользователя, Страница: 30 / 163

System booting options
Security password and anti-virus features
Green PC options, such as the time intervals before the
system and the hard disk drive go into low-power standby
mode.
SETUP also allows you to see summary information about your
system.
The SETUP program and the factory default options for your
computer are stored in the computer’s ROM BIOS (read-only
memory, basic input/output system). The configuration
information you enter is stored in an area of memory called
CMOS RAM. This memory is backed up by a battery, so it is
not erased when you turn off or reset the computer.
Starting the SETUP Program
When you start your computer, it performs some power-on
diagnostics. During these diagnostics, you may see the
following message:
Press <F2>
to enter SETUP
Press F2
to run SETUP. This message is only on the screen for a
few seconds. If you missed it, restart your computer and try
again. (If you want, you can disable this message in SETUP.)
If, during power-on diagnostics, the system detects an error in
your system configuration, you hear two beeps and see an
error message followed by this message:
Press <Fl>
to resume,
< F 2 >
to Setup
Press
F2
to run SETUP.
2-2
Running
SETUP
and Installing Drivers