48
Using the Remote Control
Setting the Projector ID
The projector’s default ID is set to Off. This lets it respond to
commands from any remote control. To change the ID, follow these
steps:
1. Press the
Menu
button on the remote control. You see the
projector’s menu screen.
2. Select
Extended > Projector ID
.
3. Use the
pointer button to highlight the new ID, and press
Enter
to select it.
4. When done, press
Menu
to exit the menu system.
Setting the Remote Control ID
The remote control’s default ID is zero. This lets you operate any
projector. To set it to operate a specific projector, follow these steps:
1. Point the remote control at the projector you want to be able to
operate.
2. Press and hold the
ID
button on the remote control.
note
If you’re using a remote
control ID other than the
default ID of zero, you have
to set the ID each time you
turn on the projector.
Содержание 6110i - PowerLite XGA LCD Projector
