Epson 6100i - PowerLite XGA LCD Projector, Руководство пользователя

Страница: 100 / 132

100
Solving Problems
green
flashing orange
It’s time to replace the lamp. See page 93 for instructions. If you continue
to use the lamp after the replacement warning, there is an increased
possibility that the lamp may break.
green
orange
No air filter. Make sure that the air filter is securely installed; see page 91.
If the error continues when the air filter is installed, there is a problem
with the air filter sensor. Stop using the projector, disconnect the power
cord, and contact Epson as described on page 109.
green
flashing orange
Low air flow. If you see a message saying that the air filter is clogged,
make sure that the air filter and is clean. If it is clogged replace it with a
new filter; see page 91.
red
flashing red
There is a problem with the fan or temperature sensor. Stop using the
projector, disconnect the power cable, and contact Epson as described
on page 109.
red
red
The projector is overheating, which turns the lamp off automatically. Wait
until the cooling fan stops, about five minutes, then unplug the power
cord. Plug the power cord back in and press the
P
Power button. Make
sure the room temperature is not above 95 °F (35 °C) and there is plenty
of space around and under the projector for ventilation.
The air filter may be clogged. Clean or replace it as described on page 91.
If the projector continues to overheat after you clean the air filter, the
problem may be caused by damage to the cooling fan or temperature
sensor. Contact Epson for help.
Warning: Except as specifically explained in this User’s Guide , do not
attempt to service this product yourself.
red
flashing red
The lamp may be burned out. First make sure the lamp cover is securely
installed. If that’s not the problem, remove the lamp and replace it as
described on page 93. If this does not resolve the problem, contact
Epson as described on page 109.
The lamp may be cracked or installed incorrectly. Check the lamp; if it is
cracked, you must replace it (as described on page 93) before you can
use the projector again.
If checking the lamp installation and replacing the lamp does not solve
the problem, contact Epson as described on page 109.
red
flashing red
The projector is shut down automatically because of an internal problem.
Remove the power cord and contact Epson for help, as described on
page 109.
Light Status Description