Epson 1815p - PowerLite XGA LCD Projector, Руководство пользователя

Страница: 36 / 204

36
Presenting with the Remote Control
4. When done, press
Menu
to exit the menu system.
Setting the Remote Control ID
The remote control’s default ID is zero. This lets you operate any
projector. To set it to operate a specific projector, follow these steps:
1. Point the remote control at the projector you want to be able to
operate.
2. Press and hold the
ID
button on the remote control.
3. While holding the
ID
button, press a numbered button on the
remote control (0 through 9) to select the desired ID. Select zero
to control all projectors, or select a number to match the ID of the
projector(s) you want to operate.
After setting the ID, you can check whether the remote control works
with a specific projector:
1. Point the remote control at the projector you want to check.
2. Press the
ID
button on the remote control. You see a message on
the screen like one of these:
If the message says the remote control is “On,” then you can use
the remote control to operate that projector. If it says “Off,” then
you have to change the ID of the remote control and/or projector
before operation is possible.
note
If you’re using a remote
control ID other than the
default ID of zero, you have
to set the ID each time you
turn on the projector.