Epson 1010, Руководство пользователя, Страница: 263 / 279

number systems
Three number systems are commonly used with printers:
binary is base 2 and uses only the digits 0 and 1. All information
in computer systems is handled in binary form represented by
electrical signals that are on or off. A binary digit is often called a
bit; any decimal number between 0 and 255 can be expressed by
an eight-bit binary number.
decimal is base 10 and uses the digits 0, 1, 2, 3, 4, 5, 6, 7, 8, and 9.
(This is the most familiar system.)
hexadecimal (hex) is base 16 and uses the digits 0, 1, 2, 3, 4, 5, 6, 7,
8, 9, A, B, C, D, E, and F. This is frequently used by programmers.
Any decimal number between 0 and 255 can be expressed by a
two-digit hex number.
on line
When the printer is on line, it is able to communicate with the
computer connected to it.
paper-out sensor
A small switch behind the platen that sends a signal
when
it is
not
in
contact with paper, informing the printer and remote computer that
there is no paper loaded, and causing the
PAPER OUT
light to go on.
paper tension unit
The part of
the
printer that fits above the platen to assure proper
paper tension in the printing area.
parallel interface
An interface that connects the computer and the printer. A parallel
interface transmits data one character or code at a time. See also
serial interface.
platen
The black roller that provides the backing for the paper during
printing.
6 Glossary