Epple Maschinen PW 30, Руководство пользователя

Страница: 23 / 50

Stand 31.07.08, PW 30, PW 30 HV, Profile roll Page 23 of 50
4.7 Hand drive
The machine only has the control mode hand drive.
You only can operate the machine with the foot switch.
4.8 Activating and deactivating bending rolls
Only activate the bending rolls if no danger exists for personnel and property
values.

Push the left foot switch

The rolls start in anti
– clockwise direction

Push the right foot switch

The rolls start in clockwise direction
or

Let the particular actuated foot switch go

The bending rolls deactivate
4.9 Adjust bending radius
You have to adjust the bending radius with the back lower roll about the hand
wheel at the right front.
For small bending radiuses you have to start first with another setting. By
alternate rolling to the front and back again with consistent infeed, you approach
to the aim measure. For large bending radiuses you can let the achieved setting
of the back lower roll and retract the material directly.
Bethink that work parts are resilient and observe this during measurements at
work parts that lay clamped in the rolls.