EPAK DS13 PRO, Инструкция по установке и эксплуатации

Страница: 9 / 33

•
Use suitable coax cables: double shielded RG6/RG11 with solid copper core is recommended for the
connection between ACU and the antenna. EPAK warranty does not cover decreased performance
due to improper wiring.
•
The maximum recommended cable length for RG6/RG11 is 50m. Make sure that the cable length
does not exceed this value. If maximum cable length is too short for your installation, favour higher
grade cables over in-line amplifier.
•
Avoid placing RF cables too close to other cables which might carry "noise".
•
Fit and secure cables properly. Use shrink tubing with heat activated adhesive to seal connectors.
•
Avoid sharp bends and kinks on cables.
•
To connect antenna and ACU, use cables in one piece; do not extend cables, do not split cables.
•
Use only high quality RF connectors.
4.4 Drilling
For an ideal mounting of the antenna all possible drilling patterns are prepared with a pre-drilled hole of 2 mm
in the bottom of the radome. Please refer to the included templates for the drilling measurements. The drilling
should have a diameter of Ø 8.5 – 10 mm for the included M8 screws. It is recommended to start with a
smaller hole, using a Ø 3.5 – 4 mm drill to avoid any damage to the mounting surface. To mount the antenna,
only use the included M8 mounting screws.
Doc ID 0354 15.12.20
Page 9/33