EPAK DS13 PRO, Инструкция по установке и эксплуатации

Страница: 24 / 33

5.3.4 Configuration -> Satellite
The user can view and configure new satellites in this section.
Each widget on the page represents a satellite and its beams.
The user can edit or delete each entry of this section. To confirm
the changes, please click on the check “
✔ ” button and to roll-
back click on cancel “
✖
” button.
You can also add new Satellites in this section.
Click on the
button on your screen, then enter the satellite name, the
position and tilt if any. To save your entry, click on the check
“
✔ ” button and to undo your changes click on cancel “ ✖ ”
button.
*Note - If the satellite is in the West orbit, you must enter a
negative number in the Position field. eg. 22West will be -22.
To add new beams for a satellite, click on “Beam+” button and
enter the beam ID, receive polarity, receive RF frequency and
symbol rate in ksym/s. The beam ID can be any number
between 1 to 9999. To save your entry, click on the check “
✔
”
button and to undo your changes click on “ ✖ ” button.
5.3.5 Configuration -> Versions
Update Section
This section is used for updating the antenna firmware or updating the ACU Software version. The user can
see an overview of the ACU software and hardware version, and the antenna information. To update the
antenna’s firmware or the ACU software, please contact the EPAK IT team.
Doc ID 0354 15.12.20
Page 24/33