EP Equipment EPT16-ET, Руководство по эксплуатации

Страница: 17 / 34

11
2.Transport and Commissioning
2.1 Using the Truck for the First Time
Only operate the truck with battery current. Rectified AC current will damage the
electronic components. Cable connections to the battery (tow leads) must be less
than 6 m .
Preparing the truck for operation after delivery or transport
Procedure
•
Check the equipment is complete.
•
Check the hydraulic oil level.
•
Install the battery if necessary (where required), (see "4.3 Battery removal and
installation" ) do not damage battery cable.
•
Charge the battery, (see "4.2 Charging the battery" ).
When the truck is parked the surface of the tyres will flatten. The flattening will
disappear after a short period of operation.
2.2 During brake-in
We recommended operating the machine under light load conditions for the first stage
of operation to get the most from it. Especially the requirements given below should
be observed while the machine is in a stage of 100 hours of operation.
•
Must prevent the new battery from over discharging when early used.
Please
charging when remain power less than 20%.
•
Perform specified preventive maintenance services carefully and completely.
•
Avoid sudden stop, starts or turns.
•
Oil changes and lubrication are recommended to do earlier than specified.
•
Limited load is 70
～
80% of the rated load.