EP Equipment CQE12R, Руководство по эксплуатации

Страница: 26 / 39

18
•
Regenerative braking
If the travel switch is set to "0", the Reach
Truck automatically brakes regeneratively.
When the speed below 1Km/h, the brake
then applies and motor brake stop.
• Inversion braking
You can set the travel switch to the opposite direction when travelling. The Reach
Truck brakes regeneratively until it starts to move in the opposite direction.
3.2.3 Lifting, transporting and depositing loads
Unsecured and incorrectly positioned
loads can cause accidents
·Instruct other people to move out of the
hazardous area of the Reach Truck. Stop
working with the Reach Truck if people do not
leave the hazardous.
·Only carry loads that have been correctly
secured and positioned. Use suitable
precautions to prevent parts of the load from
tipping or falling down.
·Do not transport witch bad handbarrow ( as
Reach Truck and stock ) .
·Never stand underneath a raised load handler.
·Do not stand on the load handler.
·Do not lift other people on the load handler.
·Insert the forks as far as possible underneath the load.
Tilt forward
Press “Tilting forward&backward” button (14) until the
angle you need.
Tilt backward
Press “Tilting forward&backward” button (14) until the
angle you need.
Warning!
In hazardous situations set the control
handle to the brake position or set the
travel switch to the opposite direction.
Warning!
Before lifting a load unit the driver
must make sure that it has been
correctly stowed and does not exceed
the Reach Truck
’s capacity.
Do not lift long loads at an angle.
Warning!
Don't lift to tiptop, to avoid shorted life
of oil cylinder.
Warning!
•
Never tilt the forks with loads raised to
1.5m or higher.
•
Don’t lift the load when the forks was
tilted forward.