20
Installation and Operating Instructions - KNX Home-Modul
Mounting and electrical installation
EN
4.3 Configuring addresses for multi-cabin
installations
You only need to configure S bus addresses in a multi-cabin installation
with an EmoTouch 3 control unit. The S bus address of the cabin you want
to control must be configured in the KNX Home-Modul for this purpose.
The Emotec, EmoStyle, EmoStyle i, Emotec IR, InfraStyle and InfraStyle i
always require the cabin address 1.
Programming the address
1
Keep the programming button pressed for approx. 5-6 seconds until the
red LED lights up.
Programming mode is then active. The green LED light goes off.
2
Quickly press the programming button once for each new address. As
delivered (address 1), this means:
a)
Press once for cabin 2. The LED flashes twice.
b)
Press twice for cabin 3. The LED flashes three times.
c)
Press three times for cabin 4. The LED flashes four times.
d)
Press four times for cabin 5. The LED flashes five times.
e)
Press five times for cabin 6. The LED flashes six times.
f)
Press six times for cabin 7. The LED flashes seven times.
g)
Press seven times for cabin 8. The LED flashes eight times.
Note that each time you press the programming button, the cabin
address increases by one. Once address 8 is reached, the count start
over with address 1.
The green LED flashes 1 to 8 times, depending on the new cabin
address.
If power is lost, the most recent address setting is automatically
saved.
If the button is not pressed for approx. 15 seconds, programming
mode ends. The red LED goes off and the green LED starts flashing. The
new address is saved.
C 31
R
8
R 14
C 33
D9
D17
IC 3
L2
L5
L6
L7
C 8
R 47
D29
D28
C 26
D24
C 2
D3
D4
C 9
L
R
C 22
R 19
R 20
R 21
R 22
R 2
R 2
R 26
C 6
C 10
IC 7
J 1
IC 6
0R
R
R 17
S W 2
R 2
R 6
C 4
C 11
R 1
R 17
S W 2
R 2
R 6
C 4
C 11
