102
Operating Instructions - EmoTouch 3
Service settings
EN
Saving the backup
1
Insert the memory card into the circuit board of the control panel.
2
Switch the off switch on the relay box to I.
The configuration data is automatically written to the memory card.
It takes a few seconds for the system to detect the memory card and
write the data to it. After inserting the memory card, wait at least
30 seconds before removing it.
3
Remove the memory card.
Save the data from the memory card on a PC or hard drive.
4
Place the front panel directly in front of the housing.
Ensure that it is aligned properly. The S-Bus connection must face
downward.
