EN-14
Installation and Operating Instructions - EOS Compact DC/HC
EN Identification
Bench sensor (optional, EOS Compact DC/HC)
You can improve heat distribution in very large saunas where air circulation
is a challenge by using an additional bench sensor.
If a bench sensor is installed, it assumes control of the temperature. How-
ever, the heater sensor does not control the cabin temperature, rather it
limits the temperature within the maximum permissible range via the
heater. Exceeding the permissible temperature range would trigger the
safety temperature limiter.
If the bench sensor fails, the heater sensor regulates the temperature.
Multisensor (optional, for EOS Compact HC only)
The multisensor is a special sensor that can function as a humidity sensor
and a temperature sensor (bench sensor). The multisensor checks either
the humidity or the temperature in the sauna cabin. In Bi-O mode, the mul-
tisensor controls the relative air humidity in %. At the same time, the con-
trol unit attempts to keep the set humidity as precisely as possible.
If the sauna is in Finnish mode, the temperature is measured and con-
trolled, not the humidity.
The heater sensor continues to monitor the temperature behaviour and
only intervenes for safety reasons when it is necessary prevent overheating
via the heater.
If the multisensor fails, the heater sensor regulates the temperature.
2.4
Technical data
Technical data
Ambient temperature
-10°C to +40°C
Storage temperature
-20°C to +70°C
Housing
Plastic
Dimensions (H x W x D)
220 x 255 x 65 mm
Weight
Approx. 1.2 kg
Power supply
400 V 3N AC 50 Hz
Switching output
10 kW
Protection class
IPx4 splash-proof
Temperature control
range
Finnish sauna mode: 30–115°C
Steamy hot air bath (Bi-O): 30–70°C
