Installation
Operating manual
Page
30
of
40
©2020 enz® technik ag
04.11.2020 Version 1.0
To set up the tool on the cleaning vehicle, enz® technik ag needs the following param-
eters for each order:
•
Pump capacity:
l/min
US gpm
•
Pump pressure:
bar
psi
•
Hose size:
mm
inch
•
Hose length:
m
feet
•
Hose material:
Plastic or rubber
If you need to make changes to the parameters, the tool needs to be
calibrated accordingly.
The tool is delivered ready for use. Once the items have been unpacked, please check
the content to ensure that you have received everything. Then screw the tool onto the
pressure hose. The tools have different thread dimensions, which can be viewed in the
“Technical Data” section starting on page
The tool normally rotates counterclockwise as standard so that it cannot unscrew itself
from the pressure hose during operation.
Ensure that there is no soiling in the tool when you are screwing it
onto the pressure hose. Particles could clog the inserts.
It is a good idea to clarify some points before use. Knowledge of the following points
is helpful during preparations and when adjusting the tool:
•
Layout of the pipes
•
Inner pipe diameter of the channel where work will be performed
•
Material quality of the channel where work will be performed
•
Type of foreign material in the pipe
•
Planned flushing direction → We recommend that you work against the
direction of flow
•
The falls in the channel where work will be performed
•
Access points to the channel
