Envision One cDLM, Инструкция по эксплуатации

Страница: 69 / 73

Envision One cDLM® User Manual
www.envisiontec.com TS-MAM-EnvisionOneCDLMUserManual-V5.0-FN-EN , 2021-12-15 Page 69 of 73
3. Remove the cap from the concentrator, and then remove the filter.
4. Take the filter to the post processing zone and spray with compressed air to remove dust and debris.
5. Insert the filter back into the base of the concentrator, return the cap, and situate the oxygen concentrator
back on its base.
6. When ready, turn the oxygen concentrator back on.
7. Allow the system to prime for 30 minutes before beginning the next print.
NOTICE
Every 6 months, the filter must be removed and replaced with a new filter. If needed, the cavity can
be cleaned with a clean dry paper towel or micro fiber cloth.
12.2.9 Maintaining EnvisionTEC Materials
Time needed : Approximately five minutes to mix material, depending on the ma 15 minutes to empty and
clean the material tray.
Maintenance frequency : Print-by-Print
To maintain EnvisionTEC Materials:
1. Protect material in the material tray from ambient light by keeping the hood closed.
2.Mix the material in the material tray before each print using the rubber spatula from the Starter Kit. To do
this:
•
Lightly skim the spatula back and forth across the surface of the material in the tray.
•
Mix carefully to avoid puncturing or tearing the film at the bottom of the domeless material tray.
•
Mix the material until it’s a completely uniform color.
3. Check the material for solids or debris. If found, filter the material. To do this:
•
Remove the material tray from the printer.
•
Set the funnel and cone-shaped paint filter on top of a separate opaque storage bottle.
•
Pour the material out by tipping a front corner of the tray, away from the vent holes.
•
Use the rubber spatula to assist in guiding the material into the filter.
•
When finished, dispose of the filter and clean the funnel with a dry paper towel.
IMPORTANT
For more specific information on handling a material, see the corresponding
Material Safety Data
Sheets
12.2.10 Checking the Safety Equipment
IMPORTANT
All emergency stopping devices and protection doors must be checked one by one and separately.
In case of defective safety equipment, shut the printer down immediately and secure it against being
switched on again.