AF24, AF4
8
, AF80 Heavy Duty Water Softeners
© 201
6
Enviro Water Solutions LLC
3060 Performance Circle, Suite 2. DeLand, FL 32724
— Rev
A
Page 7
(844) 663-3078
Installation
Install Electronic Head
Figure 3
Notice:
Follow the raised black arrows on the head of the Softener.
1. Level the Softener Tank.
Notice:
If the tank is not level, lift the tank straight up 6 inches and tap it on the ground until the tank stands
vertical. The bottom of the tank is round and the boot allows the tank to stand upright.
2. Determine the size and material of your incoming water supply line and choose the appropriate
fittings required to connect it to the Bypass Valve.
CAUTION:
Do not over-tighten any of the fittings during installation.
3.
Remove the gray cap from the top of the Softener tank.
4.
Screw the Electronic Head onto the tank hand-tight.
5.
Install the appropriate fittings onto the inlet and outlet, following the arrows on the Bypass Valve
and head.
6.
Connect the incoming water supply to the fitting on the inlet side of the Bypass Valve.
7.
Connect the outgoing water supply to the outlet side of the Bypass Valve.
8.
Firmly press one end of the discharge PVC Tubing Drain Line onto the barbed nose, and secure the
other end of the line to a drain.
Softener Tank
Electronic
Head
Discharge
Line
Outgoing
Water to
House
Wall
Incoming
Water
Supply
Holding Tank
Safety Valve
Bypass
Valve
Overflow
Barb
Brine Tank