The Horizontal Vent Kit (50-3664) must be used in conjunction with the Q1 Co-linear Vent Kit (50-
2982) and ensure that the unit air restrictors are set to fully open as this venting kit functions best
without any restriction. See owner’s manual for more information. See Owner’s Manual for installa-
tion.
This kit is NOT compatible with the Q1 fireplace configuration.
The kit is directly compatible with any E series unit.
Compatible Models:
Q1 G
eneral
I
nformatIon
Initial Installation
Step 1:
Remove the Horizontal Vent Kit from the packaging. Ensure there is no damage to the vent piping or
termination cap. If there is damage contact your dealer, distributor, or courier company before start-
ing this installation.
I
nstallatIon
:
IMPORTANT: If the factory-built fireplace has no gas access hole(s) provided, an access hole of 1.5
inch (37.5 mm) or less may be drilled through the lower sides or bottom of the firebox in a proper
workmanship like manner. This access hole must be plugged with non-combustible insulation after
the gas supply line has been installed. Cutting any sheet-metal parts of the fireplace, in which the gas
fireplace insert is to be installed is prohibited. The label plate shown on the right, included with co-
linear venting adapter kit, must be permanently attached inside the cavity of the fireplace in a visible
location.
Note: Space must be left for gas line on left side of unit for servicing purposes
Install Information:
The flue damper must be fully blocked open or removed for installation of the unit; the smoke
shelves, shields and baffles may be removed if attached by mechanical fasteners.
The fireplace and fireplace chimney must be clean, in good working order and constructed of non-
combustible materials.
Make sure that all chimney cleanouts are tight fitting and will not permit air to leak into the chimney.
Refractory, glass doors, screen rails, screen mesh and log grates can be removed from the fireplace
before installing the unit.
Install a sealed vent cap to prevent leakage of room air up through chimney.
The intake and the exhaust are 3” (76mm).
Ensure that the fireplace and chimney have been thoroughly cleaned prior to install.
50-3664 Installation
QUALIFIED INSTALLERS ONLY
Not Compatible Models:
• Q1C
• Q1CI
• Q1L
• Q1LI
• Q1G
• Q1GI
• E30L
• E30LI
• E30G
• E30GI
• E33L
• E33LI
• E33G
• E33GI
• EX32
• EX35
a
ll
I
nserts
G
eneral
I
nformatIon
