Pixel Triton User Manual
Part No.: 51322
For latest version visit:
www.enttec.com
25 October 2018
mfile ID: 4815381
Page|
6
Settings
The Settings tab allows an end user to do the
following:
•
Change a device name for identification
•
Enable/disable DHCP
•
Set a specific static IP address
•
Set a specific static NetMask
•
Set the input DMX Protocol
•
Set the output LED Protocol
•
Set the number of input universes
•
Map a universe to the output
•
Configure how colours are mapped to pixels
•
Set number of pixels that are controlled
•
Pixel grouping settings
•
Test the device and/or tape using faders
•
Reset to factory defaults
•
Reboot device
Network Stats
The Network page shows statistics for the DMX
protocol enabled. The information provided is:
•
Poll packets received
•
Last IP poll packets were received from
•
Data packets received
•
Sync packets received
•
Last port data received from
Update Firmware
In addition to providing a method to update the
device firmware this tab shows the following:
•
The boot version on the device
•
The firmware version on the device
•
The device mac address
•
The device serial number
•
DHCP status
•
Device IP address
When the firmware page of a device is accessed,
the NMU will display this unit in red
