Entrotec PRO-DPC, Инструкция по установке и настройке

Страница: 8 / 28

Initialise
8
ii. Navigate the cursor to the different network segments using 2 (up), 8 (down), 4 (left) and 6
(right). The selected segment will blink.
FIGURE 5-3
i. Press to adjust a segment and enter a new number using the keypad.
ii. Press to save that segment.
iii. Repeat steps 1-3 for each segment required and press
X
to exit the menu.
NOTE
The device will reboot if network settings are updated. This might take up to 2 minutes.
6 Initialise
NOTE
Settings differ between systems WITH and WITHOUT an Entrotec Connect Server. For systems
without an Entrotec Connect Sever, one Call Panel on the system is assigned as the SIP server.
Connect to Web Service and Initialise Device
i. Connect a laptop or PC to the same network as the Call Panel.
ii. Assign your PC or laptop an IPv4 address from the same range used by the door entry
system.
iii. Use a web browser and enter the IP address of the Call Panel in to the address bar.
FIGURE 6-1
IP address
Subnet Mask
Default Gateway
MAC Address. This
cannot be changed .