Enthermics EC770L, Руководство оператора

Страница: 21 / 44

O
PERATION
Fluid Warmer
▪
Operator’s Manual
▪
MN-39935
▪
Rev 1
▪
3/19
21
How to Operate the Fluid Warmer
Before you begin The warmer must be connected to electric power and turned on.
Procedure To operate the warmer, do the following.
Step Action
1. Select the operation mode.
▪
Press the irrigation button for irrigation mode.
▪
Press the injection button for injection mode.
To change between irrigation mode and injection mode, turn the screen off
and then back on.
2. Set the temperature using the arrow buttons .
Continued on next page
WARNING: Personal injury hazard.
Do not operate the warmer in the presence of flammable
anesthetic mixtures (with air or with oxygen or nitrous oxide).
WARNING:
Personal injury hazard.
Verify the fluid temperature prior to using the fluid. Refer to the
fluid manufacturer’s label for recommended warming
procedures.
Do not use any fluids that are warmed above the suggested
temperature.
NOTICE
Do not overload the cavity.
Refer to topic
Specification Information for the storage cavity
capacity.

NOTE:
Open the door to cool the cavity before changing
from a higher temperature to a lower temperature.

NOTE:
The irrigation temperature set-point range is
90°F – 150°F (32°C – 66°C).
The injection temperature set-point range is 90°F – 104°F
(32°C – 40°C).