Enterasys SecureStack C2, Руководство по настройке, Страница: 178 / 607

clear lacp static
5-40 Port Configuration
Defaults
If not specified, a key will be assigned according to the specified aggregator. For example a key of
4 would be assigned to lag.0.4.
Mode
Switch command, read ‐ write.
Example
This example shows how to add port
ge
.1.6 to the LAG of aggregator port 6:
C2(su)->set lacp static lag.0.6 ge.1.6
clear lacp static
Use this command to remove specific ports from a Link Aggregation Group.
Syntax
clear lacp static lagportstring port-string
Parameters
Defaults
None.
Mode
Switch command, read ‐ write.
Example
This example shows how to remove
ge
.1.6 from the LAG of aggregator port 6:
C2(su)->clear lacp static lag.0.6 ge.1.6
set lacp singleportlag
Use this command to enable or disable the formation of single port LAGs.
Syntax
set lacp singleportlag { enable | disable }
Parameters
lagportstring Specifies the LAG aggregator port from which ports will be removed.
port ‐ string Specifies the port(s) to remove from the LAG. For a detailed description of
possible port ‐ string values, refer to “ Port String Syntax Used in the CLI ”
on page 5 ‐ 2.
disable | enable Enables or disables the formation of single port LAGs.